Specifications

A 3D printed case for the Teenage Engineering Pocket Operator.Non-slip sliding case with Sci-Fi design.Easy-to-install slide case for pocket operators.Cases to eliminate annoying slipping during performance. With 4 non-slip rubber on the back side. Easy to play.The wire stand can be removed and stored inside the case, so there is no need to worry about losing it.In and out cable jacks can be used without any problem.This case does not require any parts to be assembled, just slide it on and it will hold the unit. The pocket operator shown in the photos is not included.

Related Items

Replacement Power Supply Parts for BEHRINGER Mixer MX 1604A EURORACK 110V

Odyssey 11.25″ x 8.5″ x 2.5″ Bottom Interior with Pluck Foams Case

Main Logic Board Replacement for Logitech Ultimate Ears Boom 4 Bluetooth Speaker

Oberheim OB-8 Voice Board Rebuild Kit – Watch Video!

TLM103 Black Neumann Wired Condenser Microphone Matte NEW USA

Replacement Diaphragm for Timpano TPT-RPDH2000 TPT-DH2000 Horn Driver 1 Pair

Teenage Engineering PO-14 Sub Pocket Cheap Monday Operator w/ Case

Deoxit D100L.CPK, 1.6mL Net Content 640-0331