Specifications

3d printed swivel mount for Schoeps capsules with Schoeps active connectors. Comes complete with hardware and hex-key. Microphones and shockmount are not included. The following lists the capsule spacing and base angle for each variation. To adjust the capsule angle, simply loosen the hex bolts with the supplied hex-key and rotate the clips to the desired angle. Then, re-tighten the bolts. Angles are marked in 5° increments. DINA: 17cm @ 90°ORTF: 17cm @ 110°DIN: 20cm @ 90°

Related Items

DIGIDESIGN DIGI 002 RACK MOUNT MX002RK FIREWIRERECORDING INTERFACE

CAIG RBR100L-25C Rubber Drive Cleaner and Rejuvenator 25mL Needle Dispenser

[6 PACK] Soundproofing Acoustic BEVEL Foam Tiles Wall Panels 12″ X 12″ X 0.4

Live Wire Solutions SPDI DIRECT BOX Passive Switchable Hi-Z Input to LO-Z Output

JBL 12″ Differential Woofer Aftermarket JBL 262H for JBL MRX512 M Series 8 Ohms

Groove Tubes SFX Spacestation Mark II MK2 Powered Monitor Guitar Speaker Cabinet

1x PRV RPD2500Ti Original Replacement Diaphragm for WG2500Ti Compression Driver

PHILMORE Solid State Mike Mixer Model SM195 {LT-8}